A Beginner’s Guide to Compression – Part 3: Types of Compressor

If you’ve read the first two parts of this guide, you’ll now know what a compressor does and when you might use one. For part 3, we’re looking at different types of compressor to help you choose the right tool for the job.

Single band

Most compressors are single band (as opposed to multi band – see below). This means that they react to the dynamic content of the entire frequency spectrum equally.

For example, if you’re compressing a drum bus and you’ve got a huge bass drum with lots of sub on it, the compressor will kick in against that, reducing the level of everything else along with it (which can cause pumping.)

That’s why it’s often a good idea to do any corrective EQ you need before you hit the compressor, to make sure wayward rumbles don’t destroy the dynamics of what you’re compressing.

RMS

As well as being single band, most compressors will be RMS sensitive. Simply put, the RMS level is the average level of the material. So, rather than reacting against every single peak, an RMS compressor will smooth out the overall level.

To see the difference between RMS and peak, try download PSP Vintagemeter, load two versions, set one to VU and one to PPM. The former is showing the RMS values and the latter, peaks.

Peak

Peak compressors on the other hand, as you would expect, react to peaks. These are useful for ‘spiky’ or overly percussive material, and are often put in chain after using an RMS compressor, particularly on vocals. This way you can smooth out the overall level and use a peak compressor to tame anything still sticking out.

If using a peak compressor you would of course generally use shorter attack and release times than with an RMS sensitive compressor.

Peak compressors are less common, but many stock DAW plugins give you some control over how sensitive it is to RMS or peaks.

Limiters

Although many people think of limiters as being distinct from compressors, they are in fact simply fast acting, high ratio peak compressors.

They are most commonly used in mastering to squeeze every inch of level from a track without allowing any overs (unless we want to…)

Old style limiters still allow some peaks to go through, but the introduction of the brickwall limiter (starting with the famous Waves L2) allow us to keep squeezing until it hurts (literally in some cases).

Multiband

Multiband compressors can be any and all of the above; but they split the signal into separate frequency bands, allowing you to compress the bass, mids and treble separately (or more, or less, depending on the number of bands).

Multibands are again most often used in mastering where they’re useful for:

  • Targeting specific problem frequency areas (e.g. over-enthusiastic bass, too many sibilants)
  • Squeezing every ounce of level
  • Rebalancing a mix

Multiband compressors aren’t always the appropriate tool for the job, in fact, they’re usually not, but when they are they can be a real life saver. Be careful though – it’s very easy to destroy a sound with overuse of multiband, only use it if you really need to.

And the rest…

Beyond the types covered here, there are of course many different subsets and circuit types: feed-forward, feed-back, VCA, opto…the list is practically endless.

All of these behave differently and give a slightly different sound, but the best advice for these is just to try them and see. As long as you know you’re using a single band RMS compressor (for example) it will do the job you want it to, whether it’s opto or feed-forward etc. just means it will do it in a different way.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>